Drop protection sleeve
Required DURABASE WS products
Self-adhesive wall sealing set for dry wall and floor sealing.
1 waterproof membrane 1 m x 30 m; 2 spray primer; 3 corner sealing tape 120 mm x 50 m; 4 base sealing tape 50 m;
5 Installation aid: squeegee; 6 2x 1/2″ pipe collars; 7 Drip protection sleeve; 8 Installation instructions.
waterproof membrane
Internal and external corners
Plinth seal
Corner adhesive tape with trowel protection
Installation instructions for anti-drip collar
1. position the pipe collar in the center of the connection.
2. spread the insertion sleeve slightly (detail) and place it on the pipe collar.
3 Press the insertion sleeve over the fitting with both thumbs in the direction of the pipe connection.
4 Use the insertion sleeve to push the collar of the pipe collar over the pipe connection. The sleeve collar must sit on the water connection with tension !
5. remove the insertion sleeve.
6. screw in the construction plug.
7. fold the pipe collar towards the center.
8. turn inwards again.
9. wrap the folded pipe collar around the side of the building plug.
10 The pipe collar is held together by the insertion sleeve.
11. plaster the wall surface.
12. prime the wall surface.
13. remove the insertion sleeve. Unfold the pipe collar. Carefully remove any remaining lubricant. The sealing surface of the pipe collar must remain absolutely grease-free! Remove the protective film.
14 Press on the pipe collar firmly with the spatula.
15 Apply the corner adhesive tape to the pipe collar and roll it on tightly.
16. cut the waterproof membrane horizontally and cut it out at the pipe penetration.
17 Replace the lower part of the waterproof membrane. Continue with the wall sealing.
