Applying the waterproof membranes
Required DURABASE WS products
Self-adhesive wall sealing set for dry wall and floor sealing.
1 waterproof membrane 1 m x 30 m; 2 spray primer; 3 corner adhesive tape 120 mm x 50 m; 4 base sealing tape 50 m; 5 installation aid: squeegee; 6 2x 1/2″ pipe collars; 7 drip protection collar; 8 installation instructions.
waterproof membrane
Applying the waterproof membranes to the wall and the shower tray and bathtub area
1. protective film on the back of the waterproof membrane. Sequence (1.-4.) in which the protective films are removed from the back of the sealing membrane.
2. 1. Wet wipe the yellow overlap zone. 2. wipe dry. 3. overlap the tube joint tapes, corner adhesive tapes, sealing corners and sleeves.
3. attention! Cut all waterproof membranes to length with an allowance of h + approx. 20 cm! Before attaching the waterproof membranes, determine the passage points for fittings etc. if necessary and transfer the dimensions to the waterproof membranes, see Figures D1 – D7.
4. peel off the protective film 5 cm wide approx. 20-30 cm downwards. Position and align the waterproof membrane in this area. Gradually peel off the remaining protective film further down and stick the waterproof membrane to the floor up to the corner adhesive tape. For details see pictures C 8 ff.
5. peel off the protective film 26 cm wide step by step towards the bottom. Press the upper part of the waterproof membrane onto the wall in the area of the removed cover film. Remove the remaining protective film further down and stick the waterproof membrane to the floor up to the corner adhesive tape.
6. gradually peel off the protective film 35 cm downwards and continue as before.
7. gradually peel off the protective film 35 cm downwards and continue as before.
8 . remove all protective films up to just above the corner adhesive tape and press on the waterproof membrane. Do not yet remove the protective film at the bottom of the wall/floor transition!
9. brush the waterproof membrane thoroughly into the throat of a cardboard angle by hand.
10. mark the waterproof membrane along the cardboard angle in the wall/floor (tub) area with a pencil.
11 Then use scissors to cut the waterproof membrane cleanly along the marking. Caution: Do not damage the corner adhesive tape!
12 Remove the remaining masking film from the waterproof membrane. Press the waterproof membrane firmly onto the wall and floor area and the corner adhesive tape.
13. a white finishing strip (60 mm) is glued onto the fleece-free edge strip.
14. finished waterproof membranes in the shower tray and bathtub area.
15. finished waterproof membranes in the floor area.
